Fire extinguisher holder to suspend the box

The fire extinguisher support box is recommended for secure securing the 6kg fire extinguisher box.

Applying the plastic fire extinguisher box (2920H) to avoid the breaking box and provides a stable support for the fire extinguisher box.

The assembly can only be used for the 6kg LAGO plastic fire extinguisher box.

Material: Steel. Corrosion protection: plastic coating.

Equipment: The 8mm diameter holes are already drilled on the impact.

From the back of the plastic box holding the fire extinguisher, the circular (similar) thickening is clearly visible from the inside.

Insert the clutter and determine which four will meet the pre -drilled holes. Drill exactly four 8mm diameter holes from the inside to the center of the thickening.

ATTENTION! There are several thickening inside the holding box, and once again, check which one to drill. The impression should be placed so that the lower cross-iron of the clip is placed under the fire extinguisher box.

Find holes pre -drilled on the truck chassis and try to get there.

Mark the holes on the chassis with the impact. Find at least two, at least 10 mm in diameter, or, if you can't find it, make it as far as possible, but at least 5 cm. Drill holes with a diameter and position corresponding to the holes on the chassis for the catch. Use only a recessed head and self -closing nuts to fix the chassis. Since its size is not known in advance, it is not an accessory, but it is available in any screw shop. Plug the screws through the holes made on the cloth from the inside out, then twist the impact to the chassis so that the self -closing nuts are on the other side of the chassis.

Unscrew the fire extinguisher with the impact at each of the four points: Plug the screw from the outside. Place the washer from the inside and then the self -closing mother.

Pull all four well.

Quantitative unit: pcs

English name: Fire Exting. mount